KY_BOB
Full Member
HeavyD said:Interesting, as I have been wondering about something like this, I was even thinking about drilling a few 3/4 inch holes or so along the bottom edge of the hood or some larger holes on the liner where you did your but following the frame. looks pretty good. btw KY now you just need some glow in there.
I was talking about the sheet metal itself (from one hinge to another), on the hood then finish it with some grommets or something, not to many holes or to large where it would weaken the sheet metal.KY_BOB said:Don't drill it.? It shreds.? I tried that first
It cuts easy with a sharp utility knife.?